Inertial module
PI-08M

PI-08M is our smallest inertial module for integration to your systems and designs. Essentially, it is an internal part of the IMU PI-08. It is smaller and cheaper than the IMU, not environmentally protected and has different interfaces and lower power consumption. It provides the same level of accuracy if it is correctly mounted, not subjected to severe temperature gradients or exposed to powerful electro-magnetic interference. We can provide recommendations on how to integrate and use our modules in your systems so the best performance is achieved.

Full-scale range
Bias (In-Run Stability), (1σ)
Bias (Over Temperature), (1σ)
Angle Random Walk, (1σ)
Rate Noise Density
Scale Factor
Error over temp., (1σ)
Non-Linearity , (1σ)
Bandwidth (-3dB)
Misalignment, (1σ)
g-Sensetivity

Measurement Range
Bias (In Run Stability)(1σ)
Bias (Over Temperature) (1σ)
Angle Random Walk, (1σ)
Noise Density
Scale Factor
Error over temp., (1σ)
Non-linearity
Bandwidth (-3dB)
Misalignment, (1σ)

Temperature range (operating)
Input Power
Power Consumption (3.6V input)
Interfaces
Size
Weight
Vibration (50Hz - 2000Hz)
Out Data Rate

±1800 deg/sec
3 deg/hr
< 0.015 deg/s
0.1 deg/sqrt(hr)
0.0017 deg/sec/sqrt(Hz)

0.1%
< 0.01% of FS
250 Hz
< 0.05 deg
TBD

±14 g
10 ug
0.5 mg
0.02 m/s/sqrt(h)
35 ug/sqrt(Hz)

0.05%
< 0.03% of FS
218 Hz
< 0.05 deg

-40C - +85C
2.2 V to 3.6 V
172 mW
UART, SPI
24 x 21 x 14 mm
< 10 gram
2 g RMS
250 - 2000 Hz

For all IMUs and inertial modules, we offer special boards that allow you to conveniently and correctly mount and connect our units for evaluation purposes. The boards have more common connectors and they are a very simple solution when you need a quick start or your application allows a bit extra volume for the purpose. Please, refer to our Accessories section for more details.

MANUAL

SAMPLE DATA

downloads

* - best achievable specs, provided correct mounting, no significant temperature gradients or electro-magnetic interference